When the signal source is grounded,the shielding layer should be grounded on the signal side;when it is not grounded,it should be grounded on the PLC side;when there is a connector in the middle of the signal line,the shielding layer should be firmly connected and insulated,and multi-point grounding must be avoided;When the shielded twisted pair of the point signal is connected with the multi-core twisted pair total shielded cable,the shielding layers should be well connected to each other and treated with insulation.Select a single point contact at the appropriate ground.
信号源接地时,屏蔽层应在信号侧接地;不接地时,应在PLC侧接地;信号线中间有接头时,屏蔽层应牢固连接并进行绝缘处理,一定要避免多点接地;多个测点信号的屏蔽双绞线与多芯对绞总屏电缆连接时,各屏蔽层应相互连接好,并经绝缘处理。选择适当的接地处单点接点。
GP Sorensen EL339 Pick-Up
GP Sorensen S70 Ignition Switch
GP Sorensen Distributor Cap#22-5066 Fits, 83-86 Toyota
Breaking the Chain of Low Self-Esteem .. Marilyn Sorens
Carburetor Gasket Kit 41 1941 1942 Buick 40 50 60 70 90
Carburetor Gasket Kit 36 – 38 Lincoln Zephyr Stromberg
GP Sorensen Carburetor Kit – 96-557