描述
1、如果信号电缆和电源电缆之间的间距小于15cm时,必须在信号电缆和电源电缆之间设置屏蔽用的金属隔板,并将隔板接地。
2、当信号电缆和电源电缆垂直方向或水平方向分离安装时,信号电缆和电源电缆之间的间距应大于15cm.
对于某些干扰特别大的应用场合,如电源电缆上挂接电压为220V AC,电流在10A以上感性负载,而且电源电缆不带屏蔽层时,那么要求它与信号电缆的垂直方向间隔距离必须在60cm以上。
3、在两组电缆垂直相交时,若电源电缆不带屏蔽层,最好用厚度在1.6mm以上的铁板覆盖交叉部分。
Giddings and Lewis CIMREX 67 Touch Screen (PLC1646)
Giddings and Lewis 502-03113-00 Power Supply and Driver
G&L Giddings & Lewis 800 P/N 502-02734-50 Logic I/O
G&L Giddings & Lewis 800 502-02804-50 EIA Interface
G&L Giddings & Lewis 800 502-02724-51 Console Interfac
G&L Giddings & Lewis 800 502-02723-52 CPU Control
G&L Giddings & Lewis 800 502-02722-50 Address Generato
GIDDINGS & LEWIS portable controller
Giddings & Lewis PC Support Module 502-03195-08
Giddings & Lewis Solenoid Drive Digitizing Board (3152)